Description

Model PT295-H2S is a microprocessor-based sensor designed to detect hydrogen sulfide in parts per million (ppm) level. The unit features easy one-man calibration initiated by simply activating a magnetic switch and applying the gas.

The complete sensor consists of a stainless steel sensor head assembly, a user connection board and a transmitter board assembly. All of the sensor electronics are enclosed in an explosion proof instrument box. The unit's modular design allows easy maintenance, troubleshooting and high reliability.

The unit provides a 4-20mA signal proportional to 0 to 100% of the detection range of the sensor and a fully programmable alarm relay.

The sensor transmitter board includes a three (3) digit LED display for continuous indication of the gas concentration. The calibration mode, alarm and fault status of the sensor are also indicated on the digital display. In the normal operating mode the digital display and 4-20mA reading is proportional to the gas concentration detected by the sensor. In the calibration mode the digital display indicates the calibration status, alarm relay output is inhibited and analog signal output is set to 2 mA to avoid any false alarm by the control monitor. In the sensor fault mode the transmitter drops the output signal to < 1 mA.

Model PT295 Stand Alone Sensor for H2S
Specifications

Measuring Range
0 to 100 parts per million (ppm)

Repeatability
± 2 % Full scale

Zero Drift
< 5% per year

Response Time
T90 < 30 seconds with 100% FS gas applied

Classification
Class I, division 1, Groups B,C &D

Operating Temperature
-4°F to +122°F (-20°C to +50°C)

Operating Humidity
15% to 90% RH, non-condensing

Mechanical Specifications
Length: 7 inches (178 mm)
Width: 5 inches (127 mm)
Height: 4.5 inches (114 mm)

Display
Bright 3 digit LED display

Status Indicators
Three-digit display for gas concentration,
Alarm relay status, calibration mode and
sensor fault status.

Input Power
14-28 VDC. 24 VDC nominal

Power Consumption
< 1.5 Watt. Typical 50mA @ 24 VDC

Alarm Relays
Fully programmable. 0 to Full scale range
of the sensor. Latching or Non-Latching.

Relay Ratings
SPDT Form "C" type Relay contacts
5 Amps @ 250 VAC or 30 VDC

Analog Output
Linear 4-20mA (300 Ohms max. load)
2.0 mA - Calibration mode
< 1.0 mA - Sensor malfunction

Calibration
Non-Intrusive activated by internal magnetic
switch

Cable Requirement
3 wire shielded cable. Max loop resistance of
20 Ohms @ 24 VDC nominal

Cable Entry Hub
¾" NPT Female

Other Toxic Gas sensors available
Call factory or visit www.pem-tech.com